Overclock.net banner

1 - 4 of 4 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter #1
Hey guys,

I'm sure someone else has had to do this with a different rig setup. I need to move my TT Big Typhoon from my Socket A system to my new 939 Rig.... problem is I used the sponge and mylar connector plates when I attached them to the Socket A board....

Any way to get them off the A to put them on the 939 w/out damaging them?

Any SAFE way to hook up the TT Big Typhoon on the 939 w/out the sponge/mylar?

Any where to order JUST the clip replacements?

Thanks in advance,
 

·
Registered
Joined
·
108 Posts
Discussion Starter #4
Oh great!

Yea the new board is an ASUS A8N32-SLI 939

Don't know if any of you have seen the rear of this board, but I'm assuming it's got the backplate I need.
 
1 - 4 of 4 Posts
Top