Overclock.net banner
1 - 2 of 2 Posts

·
Registered
Joined
·
514 Posts
Discussion Starter · #1 ·
Hiya guys just a quick question about grounding, when i built my rig i built it on a carpeted floor but none of my hardware touched the carpet, and i did touch the inside of case before i worked on anything, after installing my cpu i powerd on just to set the compound, i cant test any further as i havnt recieved my gpu yet, and another quick question, on my lcd poster when i plug power in before even powering on pc it says cpu init on lcd poster is this normal? when system is switched on all fans spin i note on lcd poster it goes through a few tests.....

Thanks
 

·
Initializing...
Joined
·
23,798 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top