Overclock.net banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,500 Posts
Discussion Starter · #1 ·
Hi guys,

I'm trying to decide between 3/8" and 1/2" ID tubing for my system, but with the sheer variety of tubing available, I'm never quite sure at what I look at on system pictures. I've seen huge tubing in the past and guess that was 5/8". Some tiny one too, probably 8mm. But the line between 3/8 and 1/2 is still a little blurry for me.
If you could point me to system pictures specifying the ID of the setup, that'd help me picture the difference better
 

·
Registered
Joined
·
1,222 Posts
And this is my rig with 1/2" ID tubings. Granted.. i do have thick tubings since these have 3/4" OD.



And here is pic of my other rig with regular 1/2" ID and 5/8" OD tubing

 
1 - 7 of 7 Posts
Top