Overclock.net banner

NR200P WaterCooling

3466 Views 5 Replies 5 Participants Last post by  lostsupper
I just wanted to share my NR200P Customer Water Cooled Build. I couldn't find a lot out there on good water cooling options.

XSPC TX240 Ultrathin Radiator + 2x ID-COOLING XT Series Ultra Slim 120mm Case Fan (NO-12015-XT)
- Minor modifications required so the left fan doesn't interact with the RAM
Be Quiet! Silent Wings 3 120mm PWM FAN at the bottom in intake
Alphacool Eisbaer Resevouir & Pump Block
3300X
RX580 ASUS STRIX
MSI B550
SAMSUNG 970 EVO PLUS 500GB M.2 NVME SSD
MSI MPG B550I
CORSAIR SF600 600W SFX
CORSAIR CMW32GX4M2Z3600C18

GPU stays cool with the two intake fans pushing straight into it. Typical gaming temps GPU 45-55degrees, CPU 40-50degrees.

2520979
1 - 6 of 6 Posts

· H₂O Aficionado
Joined
·
6,011 Posts
Where is the pump/res combo mounted? Nice build :) Are you able to tuck the 8 pin GPU cables to the right side? I know its tight but it might look a little cleaner.
 

· I can count to potato
Joined
·
1,478 Posts
The pump/res is integrated into the CPU block.
 
  • Rep+
Reactions: Slaughtahouse

· H₂O Aficionado
Joined
·
6,011 Posts

· Registered
Joined
·
907 Posts
Looks good. I'm curious: would there be any tangible improvement in air flow for the card if it wasn't facing the table? I always imagine if I did a SFF build I'd use a case which is vertical or wall mount something like this so exhaust can be into the open.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top