Overclock.net banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
10,016 Posts
Discussion Starter · #1 ·
I just started running OCCT v3.0.0 and I'm wondering how to configure this for the best results with the hardware listed below in my sig. right now I have it set up as follows

Type: Custom
Duration: 0h 30min
Mode: Medium data set
Priority Normal

I am only interested in making sure my overclocks are stable so I'm trying to learn the best settings for doing so.

Thank you,

N2G
 

·
Premium Member
Joined
·
5,652 Posts
The auto setup that is already there in OCCT is a pretty good start for stability testing. I usually set a custom 15 minute test, with the medium data set, and high priority for testing settings, then restart, allow the computer to get to an idle state, then run the 1 hour test. For true testing, you really want a good 8-10 hours of stress testing to really be able to call your OC 'stable' , imo.

EDIT: Also, there is a slightly updated version of OCCT here.
 
  • Rep+
Reactions: The Duke

·
Premium Member
Joined
·
10,016 Posts
Discussion Starter · #3 ·
Ok thanks. ATM I have a 420MHz CPU OC and DDR920 run 30min so far ok. I will set it to high priority and see if I get a failure. Cross your fingers for me.
 

·
Premium Member
Joined
·
5,652 Posts
Quote:

Originally Posted by N2Gaming View Post
Ok thanks. ATM I have a 420MHz CPU OC and DDR920 run 30min so far ok. I will set it to high priority and see if I get a failure. Cross your fingers for me.

Will do!
 
1 - 4 of 4 Posts
Top