[BHD_Ridder]

well from 2.4 to 3.0 to 3.1ghz, And im at 259 in my bios, max for me is 266, Should I do it and get 3.2ghz? Any suggestions?

 

[steveo42024]

Quote:

Originally Posted by BHD_Ridder well from 2.4 to 3.0 to 3.1ghz, And im at 259 in my bios, max for me is 266, Should I do it and get 3.2ghz? Any suggestions?

What are your load temps at?

 

[BHD_Ridder]

Below the 30's lol

 

[blob]

yup do it.

 

[BHD_Ridder]

Alright BRB With my Results!

 

[BHD_Ridder]

I did it to max and my PC restarted before when the Welcome screen appeared, im back at 3.1ghz, Any Suggestions?

 

[adas]

maytbe increase the vcore a bit, or maybe the memory voltage.

should be too hard, but u should go slower then just 3.1 to 3.2, go in few mhz fsb increases...

 

[Kittani]

loosten your memory timings a tad and up the vcore a tad...

 

[BHD_Ridder]

What if I mess up since im using Asus P4S800, It will Reset right?

 

[blob]

You will have to manually reset the bios. Not hard at all. Just go in there find Jumper 1 (usually) and move it to pin 2-3, after 5 seconds, move it back to 1-2.

 

[adas]

to a certain point yes, but if u accidently go to high, its jumper time.

 

[BHD_Ridder]

Going into the Bios and doing it, or is it on my mobo?

 

[adas]

the jumper is on your mobo, but thats only if your computer wont post. and if u do it u will have to manually reset all the settings in your bios like they were, becuse the jumper clears EVERYTHING exept stock config.

 

[Sai_Jao]

u cant really harm ur mobo permanently by overclocking unless u pump obsene amounts of volt into the northbridge-- so go for it

 

[BHD_Ridder]

ill raise my vcore since I know it should not do anything. So ok.