Overclock.net banner

1 - 9 of 9 Posts

·
Registered
Joined
·
257 Posts
Discussion Starter #1
Specs in sig. It is currently at 2.3 Ghz (230x10). Memory at 2-3-3-7. It is rated for DDR600 at 2.5-4-4-8, so I think I may be able to hold these timings up to -/+ 250 if I up the voltage. Everything at stock voltage atm. How should I go about doing this O/C? Go for 10 multi or 9? Load temp is 38, idle at 29 (I didn't use AS5, nor am I going to be able to get a hold of any any time soon). Any suggestions are welcome.

 

·
Registered
Joined
·
257 Posts
Discussion Starter #2
*bump*

Stepping is KACAE. Running at 2.4 currently (testing). C'mon, I'm a noob who needs some help!

ADA3700DAA5BN
KACAE 0546EPMW
1365239K50468
 

·
Registered
Joined
·
1,218 Posts
alright, here we go...try these settings

250x10
HTT x4
leave memory the same, increase volts to 2.8
increase vcore to 1.55.

If this doesn't work, it's your memory. I would recommend loosening the timings to what you already listed..
 

·
Registered
Joined
·
257 Posts
Discussion Starter #5
Lemme reboot and try those settings. Will prime during the night, I guess. I will leave the timings loose. Right now I'm concerned with the cpu and not the memory. When I get a good, stable setting I will try to tighten the timings. One step at a time...

Edit: I will just bump the voltage on the memory to 2.9, as it is under warrenty 'till past that. Though Im pretty sure I voided my warranty by the way I forced the mem into the slots, but that's a different story.
 

·
Registered
Joined
·
257 Posts
Discussion Starter #6
30 minutes prime stable at 250x10! Load at 45 C, Idled around 35. Memory at 2.5-3-3-7. Vcore at 1.55 (1.525x1.04)
 

·
Registered
Joined
·
1,218 Posts
next step is moving to 260. Dont touch the voltage, keep upping your FSB until you run into stability problems.. I wouldn't go over 1.6v yet.
 

·
Registered
Joined
·
257 Posts
Discussion Starter #8
I moved the memory to 2.9 and it was giving 2.98 in the BIOS
Puting it at 2.8 gave it 2.89 lol. Will try 260x10 after I reboot (I have to install some drivers, multi-task).
 

·
Registered
Joined
·
257 Posts
Discussion Starter #9
Lol? My load temps now are better than at 2.5. Im running OCCT 30 min test ATM.
 
1 - 9 of 9 Posts
Top