[matan_levis]

so im trying to oc my q9300 to around 3.4.
i dont know what the multiplier should be as in 6, 6.5, 7, 7.5.
and what my vcore should be.

also when trying to oc my ram
i set timings to 4/4/4/12 but after saving and restarting system fails and reboots again right after the reboot reseting other bios settings too.

the ratio i get in Cpu-z is 5:6
and i want the optimal i can get.

Thanks alot in advance

 

[Outcasst]

Try changing your timings to 5/5/5/12. That should help your system to boot. What speed are you overclocking them to?

 

[matan_levis]

Thanks for the reply,

i would probably wanna reach 3.5ghz.
ive got a noctua NF-P12 cooling my cpu.

should my voltage section be on auto ?

 

[whe3ls]

Quote:

Originally Posted by matan_levis Thanks for the reply, i would probably wanna reach 3.5ghz. ive got a noctua NF-P12 cooling my cpu. should my voltage section be on auto ?

prolly not. those boards are good overclocks. i had a x48 ds4 i was able to hit 500fsb with a quad

 

[matan_levis]

so if i want my cpu to be at 3.6ghz lets say, then what should i set my voltage on ?
i tried 3.5 and it doesnt seem so stable
is it because of the voltages ?

 

[microman]

you need to fill in your system specs. i doubt that ram will OC high enough for the 3.4 you are looking for.

 

[matan_levis]

Specs:

Gigabyte GA-EX38-DS4
Intel core 2 Quad 9300 @ 3.2GHz w/Noctua NF P12
Geforce 9800gx2
Corsair TX 750w PS
Corsair 2 x 2gb @ 5/5/5/18 xms2 ddr2 ram DHX or something, with the cooling case.
Antec P182 Case

cpu-z says my ram is 5/7/7/24 overclocked to 3.30ghz
maybe its because my ram is on auto