Overclock.net banner

1 - 4 of 4 Posts

·
Registered
Joined
·
376 Posts
Discussion Starter #1
Using the dremel bits on the power drill, would this even work?
 

·
Banned
Joined
·
3,169 Posts
Quote:

Originally Posted by this_barb
Using the dremel bits on the power drill, would this even work?
if the chuck will hold something that small you will be fine.
 

·
Premium Member
Joined
·
2,448 Posts
It depends on the bit.Most dremel bits run better at high speeds.
 

·
Premium Member
Joined
·
3,990 Posts
Won't really work.

Most drills run below 2,000RPM, While Dremel tools, Run 15,000RPM - 30,000RPM + to run peices like the cutting tool, So I doubt it would work very well at all, MAYBE the drum sander, But not the Cutting tool.
 
1 - 4 of 4 Posts
Top