Overclock.net banner

Problems With Booting Up

595 views 19 replies 4 participants last post by  Predboy 
#1 ·
When i start up i get nothing on my monitor, and its a brand new mobo

1 gb ram
40 gb and 1 80 gb maxtor
350w encer psu
gigabyte Ga-k8n51gmf-rh
and cpu newcasle 3400+ 754

but heres my dilemma, i have a ground pin missing on my cpu, could this be the problem as from looking into the pin it is a ground one
any help would be appreciated

Thanks - Mark
 
#11 ·
Well if it is a ground pin which is missing on the cpu the pc should have booted , but if it isnt it may be causing this, to be sure i would insert another cpu and check if it works
Offcourse the problem might not be the cpu ,
first try reseting the bios
then remove all components except cpu-ram, if u still get a problem here try using only one ram chip. then one by one insert the components on trying to find which one is causing the havoc
 
#18 ·
this means no signal from the mobo which most probably means that either onboard is not selected or you have a dead mobo try look for a jumper on the motherboard which selects it , or look at the manual of the mobo , if you tell me the motherboard i might be able to help you out
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top