Overclock.net banner

1 - 6 of 6 Posts

·
Artist
Joined
·
2,683 Posts
Discussion Starter #1
Hey guys. I'm attempting to sleeve the wires for my tricool fans in my Antec P180. I have THIS as the only molex removal tool I have. Can anyone tell me how to pop the molex off these tricool fans?
 

·
Artist
Joined
·
2,683 Posts
Discussion Starter #3
Quote:


Originally Posted by skkhai
View Post

If you look straight into the molex, you'll see the 4 pins... If you look closer you can see little tabs. I usually just take an exacto and push the little tabs flush with the pins. They slide right out afterwards.

+Rep my funky homosapien. I should've had better lighting. LOL.
 

·
Registered
Joined
·
1,448 Posts
even better, the newer Tri-cools have a little trap door that opens up to where you can take the pins out. they did that so peeps like us could sleeve. look at the molex connector alittle bit closer and you should see what im talking about.
 

·
Registered
Joined
·
1,034 Posts
Quote:


Originally Posted by skkhai
View Post

If you look straight into the molex, you'll see the 4 pins... If you look closer you can see little tabs. I usually just take an exacto and push the little tabs flush with the pins. They slide right out afterwards.

did the same with my P180.. i even moved the wires behind the tray while the molex was off..
 

·
The Newt in Overclock.net
Joined
·
3,000 Posts
Quote:

Originally Posted by MisterAutomatic View Post
+Rep my funky homosapien.

Mistadobalina Mr. Bob Dobalina
 
1 - 6 of 6 Posts
Top