Overclock.net banner

1 - 7 of 7 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Hey i really need some help with this i know you have to unscrew it from the bottem but the screws are so thight. Is there a special screwdriver i need or any special trick i don't want to break my vga by applying to much force.
 

·
Premium Member
Joined
·
6,318 Posts
Just make sure your using a screw driver with a tip that fits well. Don't want to strip the screws ...

Otherwise, just apply firm pressure and slowly work them off ... if your careful and have a screwdriver that's the right size, you won't hurt anything.

I have the same card and have replaced my stock cooler as well ...

 

·
Registered
Joined
·
12 Posts
Discussion Starter #4
ok maybe that was the problem then i didn't have really good screwdrivers they didn't fit wel i'll buy some new ones tommorow
 

·
Premium Member
Joined
·
10,811 Posts
Go slow and only do a couple spins at a time for each screw, going around. Don't fully undo one without starting the others, in other words. Same for putting the new one on. Even pressure at all times.
 

·
Registered
Joined
·
12 Posts
Discussion Starter #6
woot it worked with better screwdrivers they weren't that tight at all
installed my new VF900-CU and now it's time for some overclocking
 

·
Registered
Joined
·
953 Posts
Quote:

Originally Posted by MasterRandolf View Post
woot it worked with better screwdrivers they weren't that tight at all
installed my new VF900-CU and now it's time for some overclocking

Great job.... hope yor OC goes well.
 
1 - 7 of 7 Posts
Top