Overclock.net banner

1 - 9 of 9 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter · #1 ·
hi guys i am going with push and pull fans on my rx360 radiator and want to know what size of screws will work with it .
i checked on the website and it only says 6-32 case and fan screws don't know what that means
i took the current i have to a few hardware shops and they dont have the same size

any advice where i can buy online ? ebay will be preferred
thankyou
 

·
Pigeon Poop Enthusiast
Joined
·
4,288 Posts
Quote:
Originally Posted by shahs View Post

hi guys i am going with push and pull fans on my rx360 radiator and want to know what size of screws will work with it .
i checked on the website and it only says 6-32 case and fan screws don't know what that means
i took the current i have to a few hardware shops and they dont have the same size

any advice where i can buy online ? ebay will be preferred
thankyou
These are the ones I purchased some time ago,

http://www.mcmaster.com/#catalog/119/3079/=loy5jw

I also ordered these though not sure why. Might have been as a back up in case the 1 1/4" ones were too long.

http://www.mcmaster.com/#catalog/119/3079/=loy5vk
 

·
Registered
Joined
·
113 Posts
Quote:
Originally Posted by shahs View Post

i checked on the website and it only says 6-32 case and fan screws don't know what that means
It uses UNC 6-32 screws. The "6-32" is the threading type.They have the same threading as the screws you use to mount hard drives and PSU's. If you're mounting 25mm thick fans, get 30mm long screws. If you're doing fans plus a grill, get 35mm ones.
 

·
Registered
Joined
·
113 Posts
Quote:
Originally Posted by shahs View Post

Can u give me a direct link to the screws I don't quite understand the link u gave me has a long list of screws I don't know which to choose I am going to use these gts with the rx 360
http://www.ebay.com/itm/310389030988?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

Already bought 6 of them can u send a direct link to the screws


The radiator uses 6-32 threaded screws. Since the fans are 25mm thick you'll need 30mm screws which is around 1 1/4".
 

·
Registered
Joined
·
139 Posts
Discussion Starter · #6 ·
ok so i should get the 14th one from top right ?
i will order them soon
thankyou guys for your help
 

·
Registered
Joined
·
687 Posts
Quote:
Originally Posted by Zero383 View Post

It uses UNC 6-32 screws. The "6-32" is the threading type.They have the same threading as the screws you use to mount hard drives and PSU's. If you're mounting 25mm thick fans, get 30mm long screws. If you're doing fans plus a grill, get 35mm ones.
Alternatively, you can buy 50mm nylon screws and then cut them to whatever length you need.
 
1 - 9 of 9 Posts
Top