Overclock.net banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Okay so I’ve run into a bit of a snag when it comes to finally overclocking my build, essentially I don’t know what I’m doing. I’ve tried to find help on YouTube and other inter webs but couldn’t seem to find anything helpful. I can’t seem to get a stable overclock over what the base is of 3.6hz without it being able to boot to windows. Here are my specs
Ryzen 7 1800x
H100i water cooler
ASROCK x370 Killer SLI
Nvidia GTX 1050ti (4gb)
2x8 Gb g.Skill TridentZ ram 3200mhz
Phanteks p400
3 120mm fans
Any help or insight would be greatly appreciated, even if it’s just getting me up past the base clock I’ll take any performance upgrades I can get.
Also can’t seem to figure out how to get the full 3200mhz from my ram, I know Ryzen is in its infancy and may not be ready yet but even 3000 MHz would suffice. Thanks!
 

·
Registered
Joined
·
51 Posts
What settings did you use? Hopefully you didn't forget to increase the voltages.
Also check the timings for the memory if they are too aggressive..
 
1 - 2 of 2 Posts
Top