Overclock.net banner

1 - 2 of 2 Posts

·
Registered
Joined
·
817 Posts
Discussion Starter #1
I have been trying to use these Push On SATA power connectors, (but I have been having a lot of trouble with them.

Is there a trick to pushing the wires in?

It seems like everytime I use one, it will bend the small connections inside the connector (the ones that make contact with the drive).

I have been careful about pushing the wires in and also tried pushing the wires into one connector and then after the cable has been notched, use a new connector, but it seems that after one or two uses some of the connections bend and short something out.

Any suggestions?
 
1 - 2 of 2 Posts
Top