Overclock.net banner

[sponsored] ROGastic project

4450 43




Hello friends,

Guided by the need for the ultimate workstation machine, I throw myself into a project that consists of a complete change of the interior and a bit of the exterior of the CM Cosmos 25th edition case.

As you can see in the renders below, I plan to insert a large EKWB 540 radiator and provide airflow through the air tunnel with 4x120mm fans. This project also includes a complete EKWB LC system for which I will specially customize the custom distro/reservoire.

Hardware:

ASUS ROG Strix Z490 A-Gaming
Intel i9 10900
Adata XPG SPECTRIX D50 DDR4-3600Mhz RGB 4x8Gb
Adata XGP SPECTRIX S40G RGB M.2 1Tb
Cooler Master V1000 Platinum
Cooler Master MasterFan MF120 Halo White Edition
EKWB all water cooling parts and components

I know this case has been redesigned many times but I will do my best to make something different!

Thanks for following!

BR neSSa :)





1 - 20 of 44 Posts

· Rig Advisor
Joined
·
4,985 Posts
That is so interesting, so will you be creating a positive or negative pressure to force air through the rad instead of directly putting fans on it?
 

· Registered
Joined
·
904 Posts
Discussion Starter · #10 · (Edited)
That is so interesting, so will you be creating a positive or negative pressure to force air through the rad instead of directly putting fans on it?
Air will flow through the chamber, inside are air deflectors towards the radiator fins. I expect good results, we'll see when I test.

Adata XPG Spectrix D50 4x8Gb 3600Mhz :)













End short video:

 

· Rig Advisor
Joined
·
4,985 Posts
Looks good, wish the pump mount did not obscure the beautiful honeycomb over the rad. Is there clearance to consider a flat 120 mount to the underside of the honeycomb instead of the elevated mount on top?
 
1 - 20 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top