Overclock.net banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
2,726 Posts
Discussion Starter · #1 ·
I sent a Crucial m4 128gb, that I needed to get rid of to a friend, and was wondering which sata port to use. My guess would be any of the four blue or one of the two side black ports, but I just wanted to be sure. Am I correct that the single black Marvell 88SE6121 sata port shouldn't be used? Obviously he needs to turn on acpi 2.0, but what about ACPI ACIP support and ACPI Srat table options? Also is ACPI suspend mode recommended over S3? Lastly, what are the preferred SATA RAID/AHCI drivers? It would seem the AMD drivers are better than the MS drivers, but again I'm really not sure.

I haven't owned an AMD system in quite awhile. so any help would be greatly appreciated.
 

·
Registered
Joined
·
40 Posts
How did this go? I just installed and not getting the best speeds out of the drive and trying to figure out if it is just this board or I missed something in setup.
 
1 - 2 of 2 Posts
Top