Overclock.net banner

stability issues

330 Views 8 Replies 4 Participants Last post by  DREWK281
i have the setup listed below. last week i overclocked to 3.0 and had a major system crash. after i pulled the battery and reset the cmos i got it working again, i believe that i over heated the nb chipset at that time. now i have it set to 2.58ghz 235fsb x 11 mulitplier, 1.425v. ram set at dr333 timing pretty much stock 2.75v thougth. now its freezing intermittently and this morning it wouldnt boot for me so i reset the cmos. but what do you think is my problem???? the board bad? or the ram holding me back????
1 - 1 of 1 Posts

· Premium Member
Joined
·
51,319 Posts
You say pretty much stock... have you upped the vdimm, vcore and bridge voltage?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top