Overclock.net banner
1 - 10 of 10 Posts

·
Programmer
Joined
·
28,696 Posts
Discussion Starter · #1 ·
i just ordered a new cooler, the NV120 Premium from zerotherm. It does well on the reviews with Q6600 overclcoked and overvolted big time lol. am also getting AC5 thermal.

will these settings do?
Vcore=1.5v=Vdrop actual Voltage will be 1.4v
FSB speed=?
Multi=9
FSB Vol=?
chipset=?
FSB
RAM Ratio=1:1
can i get 3.3ghz with this configuration?

will these settings work? can you help fill the missing gaps? thankyou.
 

·
Registered
Joined
·
695 Posts
Chips can vary quite a lot, but I think most any Q6600 will hit 3.3 without trouble. A good one with a low vid can go a bit higher than that.

As for the missing stuff, I'd leave chipset on auto, FSB vol on auto and slowly up the FSB untill it gets unstable. Of course if you know what you want (3.3) and you know your multi (9) then you know the FSB you need to set to make that happen
 

·
Registered
Joined
·
1,140 Posts
yes it can be done quite easily. Just set your fsb to 366 and I will bet that you can do this on a 1.3 vcore. I have done it with mine with rock stable results.
 

·
Programmer
Joined
·
28,696 Posts
Discussion Starter · #5 ·
i dont think its guna happen on 1.3v. i can only just get stock speeds stable at 1.29v lol.
 

·
Registered
Joined
·
1,140 Posts
LOL, I have a 1.21 and I was 8hours stable on prime95. 1.29 though, I will bet 1.36. I don't think there should be any reason for 1.4v. Let us know how it goes.
 

·
Programmer
Joined
·
28,696 Posts
Discussion Starter · #7 ·
i think i will set it at 1.45 in the bios and the vdrop will make it run at 1.35v. i could try that and then run at 3.2-3.3ghz small fft prime95. the more i oc my quad, the more fps i get from my 4870 in 3dmark06 due to the bottleneck from the small screen and small res lol.
 

·
Programmer
Joined
·
28,696 Posts
Discussion Starter · #8 ·
Thread closed.
 

·
Registered
Joined
·
1,589 Posts
Quote:


Originally Posted by BradleyW
View Post

Thread closed.

Thank you! Ive been watching this thread for 5 months now waiting for someone to close it!
 
1 - 10 of 10 Posts
Top