Overclock.net banner

Target 3.3GHz on Q6600, can it be done?

280 Views 9 Replies 6 Participants Last post by  SgtSpike
i just ordered a new cooler, the NV120 Premium from zerotherm. It does well on the reviews with Q6600 overclcoked and overvolted big time lol. am also getting AC5 thermal.

will these settings do?
Vcore=1.5v=Vdrop actual Voltage will be 1.4v
FSB speed=?
Multi=9
FSB Vol=?
chipset=?
FSB
RAM Ratio=1:1
can i get 3.3ghz with this configuration?

will these settings work? can you help fill the missing gaps? thankyou.
1 - 1 of 1 Posts

· Registered
Joined
·
864 Posts
Chips can vary quite a lot, but I think most any Q6600 will hit 3.3 without trouble. A good one with a low vid can go a bit higher than that.

As for the missing stuff, I'd leave chipset on auto, FSB vol on auto and slowly up the FSB untill it gets unstable. Of course if you know what you want (3.3) and you know your multi (9) then you know the FSB you need to set to make that happen
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top