Overclock.net banner

This guy's first build and overclock!

1310 Views 28 Replies 10 Participants Last post by  1nf1n1ty
Alright, I finally got off of my my but and bought the parts to my system. I am a noob so any tips or advice would be great (do have a decent understanding of how everything works, however).

Intel Core 2 Quad Q9550 @ 3.61 (highest temp running P95 is around 66C)
Gigabyte GA-EP45-UD3P
OCZ Gold 4x2GB DDR2 800 @ 850 5-5-5-15
Antec Signature SG850 Power Supply
Zalman CNPS9500 w/ Arctic Silver 5
XFX GeForce GTX285
WD 300GB VelociRaptor
2x WD 1TB Caviar Black
Creative X-Fi Titanium
Coolermaster HAF
Windows Vista 64bit

I was surprised at how easily everything went together. Putting the CPU fan on was the worst part, I thought I was going to break it for sure. Pushed the power button and tadda, everything was good to go on the first try. I was hoping to get some suggestions on my overclocking and get input as to how high I'll be able to take it based on what I have so far. I was hoping for 3.8GHz which would put my ram at 890MHz. Which brings me to: what is the highest this ram should go?

Thanks guys.
  • Rep+
Reactions: Izvire
1 - 1 of 1 Posts

· Registered
Joined
·
1,769 Posts
That ram will probably do around 900 MHZ with loose timings. Though I'd keep it at a 1:1 ratio while overclocking. I think 3.8 should be easily achievable with that board, cause its one of the best out there to overclock quads. Just keep pushing that FSB up, and when it wont boot, give it some more vcore. Best of luck with it and very nice build you got there.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top