Overclock.net banner
1 - 12 of 12 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
I just built my new loop, loop consides of:

XPXC Dual Res with Laing DDC Pump
HWL GTX240
Swiftech Apogee XT
EK Multi Option Res
GTX470
GTX470 (connected via an EK SLI Bridge)
HWL GTX360

I have a 2nd res as i needed a way to fill the loop, (cant use the dual bay res filling port)

Problem i have is I have EXTREMLY low flow rate,

http://imageshack.us/photo/my-images/35/img2461j.jpg/

That air bubble between the CPU and the Cylinder Res is just sitting thier, I also cant feel much flow in the pipes (from touch).

I have no idea what is wrong here,

Anyone ?
 

·
Storage Nut
Joined
·
21,146 Posts
Quote:


Originally Posted by andrewmchugh
View Post

MAN... lol. that res in the center has broken your loop.

remove it.

Who told you do put a res there?!

That^ you shouldn't set it up that way...
 

·
Registered
Joined
·
61 Posts
Discussion Starter · #8 ·
The top of that cylinder res has 2 verticel pipes going down, way below the water level,

I didnt plan on 2 res, just couldnt use the bay res fill port as it cant be pulled out due to a pipe connecting that directly to the 240.

Needed someone of getting water into the system. Only issue was getting water to the bay res.
 

·
Registered
Joined
·
2,583 Posts
Quote:


Originally Posted by Cygone
View Post

Resevoires dont break loops, they are a closed system, as long as the inlet the outlet are both under water

look at the pic there not under the water there above
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top