[bl1tzk1213g]

I have a bare vid-nx295 that I bought but it didn't have any accessories. Does anyone here have or know where to find the cutting guide for the thermal pads? I looked online but couldn't find any. Thanks!

 

[Forsaken_id]

http://www.koolance.com/support/files/manual_vid-nx295_d100eng.pdf

 

[bl1tzk1213g]

I've seen that but it didn't have the actual cutting guide to trace-cut the thermal pad though. Should I just tract the block itself?

 

[Forsaken_id]

I'd just use the pics as reference and cut the pads in similar size.

 

[bl1tzk1213g]

I'd probably try that too hehe.

 

[Phos]

Buy a 65 gram tube of MX-2 and cover the entire card.

Seriously, the thermal pads aren't conductive, so just make sure they cover everything they need to and don't prevent the block from mounting up correctly. There's a pretty good amount of wiggle room.

 

[Phos]

Buy a 65 gram tube of MX-2 and cover the entire card.

Seriously, the thermal pads aren't conductive, so just make sure they cover everything they need to and don't prevent the block from mounting up correctly. There's a pretty good amount of wiggle room.

Edit: Whoops, forum was pretending like I didn't post this post.

 

[bl1tzk1213g]

I don't have money to waste for that much thermal paste

There aren't any good thermal pads out there?