Overclock.net banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Hi guys just a quick question. I'm running 2x 5870 in crossfire with a GTS 250 for Physx. Since i installed the physx card smartdoctor wont work.
So if i un install the 250 card and then use smartdoctor to adjust my voltage, will the adjusted voltage stick if i uninstall smartdoctor again. So in summary is the voltage adjustment only going to work with smartdoctor running or will it be independant after the adjustment to voltage.
Cheers
 

·
Registered
Joined
·
7,418 Posts
I have one 5870 and a GTS250 for physX and no problems, i flashed the asus Bios for volt tweak in ATi and i tweked the bios in GTS250 with Nibitor and all runs fine
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
Thanks guys for the quick response.
I tried you suggestion Gazza, but winflash wont work for me. I'm running windows 7 64bit ultimate with latest ati drivers so i could not flash my modded bios. The ati flas method was unsucsessful too.
Any other suggestions?
Cheers
 
1 - 4 of 4 Posts
Top