Overclock.net banner

Water Cooling didnt change my temps at all over air :(

1632 Views 34 Replies 18 Participants Last post by  mtbhrd
Hey guys, I finished setting up my WC loop today. I actually changed it, before the rad was mounted inside, then I put it outside the case, and the temps still are the exact same as when I was air cooling with the vendetta 2.

CURRENT LOOP


Earlier Loop (about 5 hours ago loop)



What would be causing me to have to temp change?

I have 3 fans on the rad. I ordered 4 Scythe Slip Stream Kaze Jyuni 120MM Fan 1200RPM 68.5CFM 24DBA

The loop consists of DD CPX-PRO --> MCR220 --> Apogee GTZ --> Temporary custom res --> back to pump
1 - 3 of 3 Posts

· Premium Member
Joined
·
3,160 Posts
Quote:


Originally Posted by [email protected]
View Post

Have the pump connected directly to the inlet of the GTZ instead of the radiator. The GTZ is pretty restrictive.

Why would you want that? The pump does dump some heat out so its pretty logical that the rad should go infront for the coldest possible water to hit the cpu. Also the GTZ isn't restrictive enough to make it a chore for the pump.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top