[kga943]

i have a water cooled pc with clear rubber hose and the hoses are sucking closed,i put some wire ties around them and it helped a little but is there a way to fix it for good,or is there something else wrong

 

[onizuka]

Get some anti kink coils

 

[_AKIMbO_]

Get some 45 degree or 90 degree rotary fittings. Some pics would help us determine the best way to solve your problem.

 

[GingerJohn]

Sucking closed? You must have a beast of a pump or very soft tubing, it is more likely that you are trying to turn too tight a bend. Show us some pics, as _AKIMbO_ said. There may be a better way to route your tubing to avoid kinks, or use some angled fittings.

 

[Satogd]

could be just very soft tubing or over time your tubing has gotten soft (it happens)
replace it with new tubing

if its in a bend anti-kink coils (promchill makes some)

 

[kga943]

 

[t-ramp]

You shouldn't have that much tubing for a CPU-only loop. Either figure out a way to run the tubing in a more direct fashion, or completely take out one of the radiators.

 

[kga943]

i purchased this unit from micro center already put together and they said it needed 2 radiators because it ran hot with one,would this be the reason for it sucking some of the hoses closed its been ok for 4 months

 

[AdvanSuper]

Two rads? Please list your whole system spec on here (and water cooling components) or in your signature like everyone else.

http://www.overclock.net/specs.php