Overclock.net banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
3,990 Posts
Not too shabby, But when I saw the rails, I essentially fell out of my chair screaming "WHERE IS YOUR GOD NOW?!?!?!?"


Seriously though man, Those rails are BRUTAL!
 

·
Premium Member
Joined
·
4,325 Posts
That 12v rail is borderline not good. If you can I'd take a multimeter to your MOBO and measure it. That could cause a stability problem for you later on down the road if the software is reading it right.
 

·
Registered
Joined
·
3,473 Posts
Discussion Starter · #4 ·
lol i assume you mean my +12v rail? hmm i hope its reading right, ill hop into bios and see what it gives me.BIOS was reading 11.9 on my +12v rail so i thinks its the combo of pc wiz and my mobo. its about time for an upgrade anyways.
 

·
Registered
Joined
·
1,122 Posts
more than likely any software you use to monitor voltages will give a mis-reading. Check that bugger with a voltmeter to make sure.
 
1 - 5 of 5 Posts
Top