Overclock.net banner

Xigmatec's "Unique Rubber Anti-Vibration System" Fails Me

342 Views 1 Reply 2 Participants Last post by  Marshmellow17
Well I had the Xiggy cooler installed for a few weeks, reinstalled it once to put in the mounting bracket. Yesterday I noticed my temps a little higher than usual - about 5c more idle, 7-10c more load. When I looked at the fan, the radiation fins are actually bent, because the rubber pins are sliding down the heatsink. So is there a way to fix this - I'm not comfortable going over 3.3 now.

1 - 2 of 2 Posts
Reseat the heat sink. The fan rubbers aren't the reason for the bad cooling.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.