Hey,
Running into an issue with my Benq Zowie XL2720 and my Asus Strix RTX 2060 where the display port is being weird and not working consistently. I have received both the no signal and out of range messages from my monitors before it boots into Windows, or if I do get into windows I'll turn the monitor off and then try to turn it back on and receive no signal detected, the only thing that has consistently remedied this was unplugging the display port and reconnecting it.
My resolution is 1920x1080 @ 144hz, I never had an issue with my GTX 1050ti at the same settings, but I was using exclusively Dual Link DVI to my monitor, I unfortunately don't a have a Dual Link DVI port to try on my new card.
I have tried updating drivers for the card, drivers for my monitor (also used the generic pnp monitor driver), got a new display port cable..same thing, tried both display ports on my card, same thing. What I find interesting is when I view BenQ Display Pilot, it shows that my refresh rate is at 144hz - same as nvidia control panel and windows; but below it says the recommended timing is 60hz? Odd, but my monitor should support 144hz.
Please share any and all ideas.. it's getting kind of annoying unplugging the display port cable every 5 or so boots..its weird that its not a consistent thing; it happens a couple times a week really.
As far as I know I have turned off any and all power saving related functions too, I have used the last few iterations of the nvidia drivers and have done the clean install option through nvidia experience.
I feel like I am running out of ideas to spitball and troubleshoot - I should have a hdmi cable somewhere I could see if I have issues at 60hz
Thanks in advance
Gabe
Running into an issue with my Benq Zowie XL2720 and my Asus Strix RTX 2060 where the display port is being weird and not working consistently. I have received both the no signal and out of range messages from my monitors before it boots into Windows, or if I do get into windows I'll turn the monitor off and then try to turn it back on and receive no signal detected, the only thing that has consistently remedied this was unplugging the display port and reconnecting it.
My resolution is 1920x1080 @ 144hz, I never had an issue with my GTX 1050ti at the same settings, but I was using exclusively Dual Link DVI to my monitor, I unfortunately don't a have a Dual Link DVI port to try on my new card.
I have tried updating drivers for the card, drivers for my monitor (also used the generic pnp monitor driver), got a new display port cable..same thing, tried both display ports on my card, same thing. What I find interesting is when I view BenQ Display Pilot, it shows that my refresh rate is at 144hz - same as nvidia control panel and windows; but below it says the recommended timing is 60hz? Odd, but my monitor should support 144hz.
Please share any and all ideas.. it's getting kind of annoying unplugging the display port cable every 5 or so boots..its weird that its not a consistent thing; it happens a couple times a week really.
As far as I know I have turned off any and all power saving related functions too, I have used the last few iterations of the nvidia drivers and have done the clean install option through nvidia experience.
I feel like I am running out of ideas to spitball and troubleshoot - I should have a hdmi cable somewhere I could see if I have issues at 60hz
Thanks in advance
Gabe
