[webwilli]

Yeah ran okay though but just wont go back to 5200 and get all the sensors back...

You can try maybe this

https://skatterbencher.com/2021/11/04/alder-lake-overclocking-whats-new/#MR_Test2_Jumper

Every ASUS ROG Maximus Z690 motherboard has a special function called MR_TEST2 which unlocks the ability to flash a new SPD on your DDR5 memory. You’ll need a special tool for this, but I’ll show you how it works nonetheless

1. First, insert a jumper onto the MR_TEST2 header
2. Then, put your target DRAM module onto slot A0 (the slot on the left)
   1. If this DRAM does not boot due to broken SPD, simply disable both channels in the bios
3. Put Source DRAM into other slots
4. Then, go into the BIOS and enter the Extreme Tweaker Tweaker’s Paradise submenu
   1. Here, set SPD Write Disable to FALSE
5. Now, go into the operating system and start the SPD flashing tool
6. Select target slot to be source DRAM. In our case, that’s the module in the third slot. Click Read from target.
7. Now you can edit the SPD, including all 5 XMP 3.0 profiles. You can also save a copy on your hard drive.
8. When ready, select target slot to destination slot. In our case A0.
9. Then click Write, wait and reboot.
10. You can remove the jumper after if you wish

 

[webwilli]

Can anyone explain, why my RunMemtestPro is running so fast??

100% in about 3 Minutes

When I´m compare it to this screenshot:

*Official* Intel DDR5 OC and 24/7 daily Memory Stability...

Let it begin, boys... @cstkl1 @Nizzen @PhoenixMDA http://www.adata.com/us/ https://gskill.com/ There's this guide: MemTestHelper/DDR4 OC Guide.md at oc-guide · integralfx/MemTestHelper While it's written for DDR4, and the specific timing recommendations don't really apply...

www.overclock.net

my MB/s are much higher.

The original MemTestPro running in normal speed.
Other Versions of RunMemTest Pro does the same.
It seem, that 100% in MemTestPro are 1000% in RunMemTestPro.